A tie-bolt sealing system, both around and inside the sleeves.

FormRing

The ULTIMATE seal for formwork

The Manorteq FormRing is the simplest solution to seal externally around a sleeve of a tie-bolt.

This revolutionary solution seals the external surface of a formwork spacer / sleeve.

The FormRing prevents water leaking around the formwork spacer / sleeves which occurs as a result of the shrinkage of concrete. It will stop water pressure up to 6 bar.

The FormRing is made from the same material as the HydroBar Evo.

This water-activated, self-expanding sealing solution is revolutionary. It ensures a perfect seal, stopping moisture / water infiltration. 100% watertight, quick, and easy to install.

Works as a system in combination with Manorteq FormPlug.

Size: 24 mm internal diameter to seal sleeves with an external diameter of 24 mm – 30 mm.

Installation of FormRing

The FormRing should be installed over the outside of the formwork spacer, centred in the middle. There should be a minimum of 100 mm from any exposed surface of the concrete.

Due to its soft and elastic composition, each FormRing can be easily installed on spacers.

Dipping the spacer in clean water will make the installation easier.

Installation of the product under continuous rain should be avoided as premature swelling might occur.

If premature swelling occurs, the product will return to its original dimensions after drying.

Watch our FormPlug and FormRing installation video

Play Video

Please note: This information is for general guidance only. It does not constitute as a detailed guide for a specific application. Due to the unique circumstances of every site, each installation must be assessed on a project-by-project basis as there may be many variables to consider. Independent professional advice should be sought on each installation. The information is to the best of Manorteq Ltd.’s knowledge and belief, accurate and reliable of the date indicated. However, no representation, warranty or guarantee is made to its accuracy, reliability, or completeness.

Download

FormRing

Technical Data Sheet

4.8 MB

FAQ’s

1It’s hard to slide the FormRing on the sleeve. What can I do?

Dip in clean water momentarily, this will allow the rubber to slide on to the sleeve as though it has been lubricated.

2What size will it fit?

As standard, it will fit an external diameter of 24 mm to 30 mm. The ring stretches.

3Will the products interfere with the Xypex waterproofing system

No. All Manorteq ancillary products are developed and selected to integrate seamlessly with the Xypex waterproofing system, as well as others.

4Does the sleeve need to be removed?

No. This product can be used without removing the sleeve.